Strange face on a saw hammer.

Got a question? New to the forum? Feel free to post your questions here.
Sawman
PostsCOLON 173
JoinedCOLON October 1st, 2013, 12:57 pm
LocationCOLON York. U.K

Strange face on a saw hammer.

Post by Sawman » August 25th, 2018, 12:15 pm

Got these today after a long wait for the price to come down.
DSCF0892 3.jpg
The question is why does one of them have a ridge on it.
DSCF0897 2.jpg
It is on both faces and it appears to been made that way not someone messing about its just to well done. Any ideas.
DSCF0899.jpg
DSCF0900 2.jpg

King Karri Tree
PostsCOLON 25
JoinedCOLON November 15th, 2015, 5:41 am
LocationCOLON South West of Western Australia

Re: Strange face on a saw hammer.

Post by King Karri Tree » September 11th, 2018, 5:05 am

It looks like a rock hammer??

Only a guess though.

Gavin Longrain
PostsCOLON 653
JoinedCOLON May 17th, 2012, 10:51 am
LocationCOLON Dalbeattie, near Dumfries, Scotland
CONTACTCOLON

Re: Strange face on a saw hammer.

Post by Gavin Longrain » November 1st, 2018, 1:10 am

A sawsmith showed me similar hammer which he called a 'peck' hammer'. He used this to hit a hollowed area to raise it i.e. he did not have to turn the saw over. It did not quite make sense to me, but I saw him use it and it worked. You could try it on scrap metal and find out.

User avatar
Jim_Thode
PostsCOLON 728
JoinedCOLON June 28th, 2012, 9:34 am
LocationCOLON Onalaska, Washington State, USA
CONTACTCOLON

Re: Strange face on a saw hammer.

Post by Jim_Thode » November 1st, 2018, 10:33 am

This is what John Starling wrote about the funny faced hammer:
The hammer on the far right, I found after a lengthy discussion with other saw filers, This hammer is called a hatchet head. It was used in tensioning Black saws and Sash gangs. Black saws are saw plate that have just been forged and they need to be broke down and tensioned, with this hammer. Then they are ground after, to remove any marks and inclusions in the surface of the saw plate. They are also used to straighten chipper and planer knives, when first made and the plate is then ground flat.

BUTTON_POST_REPLY