how much set to cut a log in the water?

Got a question? New to the forum? Feel free to post your questions here.

how much set to cut a log in the water?

Postby Gavin Longrain » November 3rd, 2017, 11:56 am

I need to saw a tree in Dumfries in front of the rowing club in waist depth water with a two man cross cut, would it be possible to borrow such a saw? It will get wet!

The above from a friend who wants to borrow a saw. I think I need to give him one with a lot of set because of waterlogged timber. I have one at 40 thou.
Gavin Longrain
 
Posts: 646
Joined: May 17th, 2012, 10:51 am
Location: Dalbeattie, near Dumfries, Scotland

Re: how much set to cut a log in the water?

Postby Jim_Thode » November 3rd, 2017, 3:57 pm

I've cut a submerged log with a normal saw with normal set, about 0.012". It cut fine and the water make a good lubricant. If the log is saturated it should be swelled as large as it is going to get and should not swell any more because it is cut.

Several years ago there was a project to clear a water trail with crosscuts. Juniper Springs Canoe Run
Report at:
http://www.wilderness.net/toolboxes/doc ... ticle2.pdf

Here is a past thread on under water cutting:
http://www.crosscutsawyer.com/viewtopic.php?f=4&t=954

Jim
User avatar
Jim_Thode
 
Posts: 684
Joined: June 28th, 2012, 9:34 am
Location: Onalaska, Washington State, USA

Re: how much set to cut a log in the water?

Postby trailcrew » November 4th, 2017, 4:34 pm

The saws we used at Congaree NP to cut in the swamp were initially set at 12 thou. We saw a lot of bind in the cuts so I widened the set to 20 for a crescent ground saw and 25 for flat saws. Didn't seem to have any more problems.
Josh
User avatar
trailcrew
 
Posts: 370
Joined: February 16th, 2011, 9:47 am
Location: Asheville, NC


Return to Crosscut saws 101

Who is online

Users browsing this forum: No registered users and 2 guests

cron