Superior,ID. saw

Post here if you are trying to identify a saw, or want to discuss specific features of saws that can be used for identification.

Superior,ID. saw

Postby Starling_Saw » September 10th, 2017, 6:49 am

Looking for information on this saw. It was found on a fire in Idaho. It looks like a Canadian version because of the three holes.
Posts: 207
Joined: February 19th, 2011, 9:02 am
Location: Southwest Washington State

Re: Superior,ID. saw

Postby Trailsawyer » September 12th, 2017, 8:27 am

This is an unusual pattern, for sure!
I suspect that it might be an Atkins, as I have seen the directional rakers on their drag saw blades.
The closest thing I have found is in the 1941 Atkins catalog - model/style No. 542. The 542 has the directional rakers the full length of the saw however.
Posts: 82
Joined: July 1st, 2012, 7:27 am
Location: SW Washington State

Re: Superior,ID. saw

Postby Jim_Thode » September 12th, 2017, 7:05 pm

An interesting tooth pattern. I see it looks like the one way rakers are not swaged. Based on David R.'s one way raker saw that may be a good idea not to swage the rakers. David made a small saw with hooked/swaged shaped rakers and it did not seem to work. The rakers would just dig in. In either case it is oblivious that the one way rakers did not become very popular. However I have seen vintage filing instructions that recommended putting some lead in the last few rakers and that makes some sense for larger logs where the rakers would tend to kick cuttings out of the cut rather then into the center of the log.

This is David's saw:

I think David also had a one way raker vintage saw but I don't know the brand/model.

User avatar
Posts: 703
Joined: June 28th, 2012, 9:34 am
Location: Onalaska, Washington State, USA

Re: Superior,ID. saw

Postby Dale Torma » September 24th, 2017, 8:55 am

Interesting variation!
Dale Torma
Posts: 123
Joined: April 18th, 2016, 11:18 am

Re: Superior,ID. saw

Postby CANbike » November 16th, 2017, 7:09 pm

Starling_Saw wrote:Looking for information on this saw. It was found on a fire in Idaho. It looks like a Canadian version because of the three holes.

What does the center of the saw look like?

Based on the first photo, the saw looks a lot like a Disston Toledo.


Posts: 1
Joined: November 16th, 2017, 6:02 am

Return to Saw ID

Who is online

Users browsing this forum: No registered users and 2 guests