Leveling and Tensioning

A forum about crosscut saw filing

Re: Leveling and Tensioning

Postby Double Ott » November 22nd, 2012, 6:46 pm

Diabolo, Thank you, Tom
Double Ott aka, Tom
Double Ott
Posts: 143
Joined: April 21st, 2012, 2:28 pm
Location: N Central WI and U.P. MI.

Re: Leveling and Tensioning

Postby Diabolo » November 23rd, 2012, 6:11 am

Tom, these are the roll-tensioning marks I was refering to.

Posts: 149
Joined: September 20th, 2012, 2:05 am
Location: France

Re: Leveling and Tensioning

Postby BD Rec » June 28th, 2013, 5:29 am

This is a great thread! Thanks for sharing your experience everyone. I am tracking this because I have 2 saws that have what I call "Smokejumper Bends" in them. There is not a defined area of the saw that is bent, the whole saw hangs with a curve from tip to tip. I have straitened ones like these in the past by hammering them flat, very time consuming and hard (at least I am) on the saws. Could these saws be rolled to take that type of bend out? Or am I way off base?
BD Rec
Posts: 81
Joined: November 14th, 2012, 5:57 am

Re: Leveling and Tensioning

Postby Starling_Saw » June 28th, 2013, 7:40 am

If you could find a sheet metal fab shop with a wide roll would be optimum. In a saw shop we use the narrow stretcher rolls and roll multiple times to accomplish it.. smoke jumpers bend the saw in a horseshoe shape and it makes cross bends mid saw body. Long saws rolled into a crate tends to bend the whole saw and more so on the narrow ends. Both will be a lot of light hammering either way.
Posts: 210
Joined: February 19th, 2011, 9:02 am
Location: Southwest Washington State


Return to Filing

Who is online

Users browsing this forum: No registered users and 2 guests