casting or fabricating climax handles?

Discussions about other types of tools, logging history, trail maintenance, etc.

casting or fabricating climax handles?

Postby Gavin Longrain » January 4th, 2018, 12:05 pm

I would like to source Climax handle-fittings.
Is it feasible to cast them?
Can they be done in Bronze?
Gavin Longrain
 
Posts: 647
Joined: May 17th, 2012, 10:51 am
Location: Dalbeattie, near Dumfries, Scotland

Re: casting or fabricating climax handles?

Postby Jim_Thode » January 4th, 2018, 5:10 pm

You can find a mostly vintage set on ebay now:
https://www.ebay.com/itm/ONE-PAIR-Vinta ... SwYc5aIasW

Also there are rather light duty ones available at:
http://crosscutsaw.com/product/431-climax-saw-handles/

And:
https://www.ebay.com/itm/ONE-PAIR-Two-M ... Swr~lYp4Tp

You could likely cast them but the cost may be more then they can be found.

Jim
User avatar
Jim_Thode
 
Posts: 692
Joined: June 28th, 2012, 9:34 am
Location: Onalaska, Washington State, USA


Return to Other General Discussion

Who is online

Users browsing this forum: No registered users and 3 guests

cron