I would like to source Climax handle-fittings.
Is it feasible to cast them?
Can they be done in Bronze?
casting or fabricating climax handles?
-
- PostsCOLON 653
- JoinedCOLON May 17th, 2012, 10:51 am
- LocationCOLON Dalbeattie, near Dumfries, Scotland
- CONTACTCOLON
- Jim_Thode
- PostsCOLON 720
- JoinedCOLON June 28th, 2012, 9:34 am
- LocationCOLON Onalaska, Washington State, USA
- CONTACTCOLON
Re: casting or fabricating climax handles?
You can find a mostly vintage set on ebay now:
https://www.ebay.com/itm/ONE-PAIR-Vinta ... SwYc5aIasW
Also there are rather light duty ones available at:
http://crosscutsaw.com/product/431-climax-saw-handles/
And:
https://www.ebay.com/itm/ONE-PAIR-Two-M ... Swr~lYp4Tp
You could likely cast them but the cost may be more then they can be found.
Jim
https://www.ebay.com/itm/ONE-PAIR-Vinta ... SwYc5aIasW
Also there are rather light duty ones available at:
http://crosscutsaw.com/product/431-climax-saw-handles/
And:
https://www.ebay.com/itm/ONE-PAIR-Two-M ... Swr~lYp4Tp
You could likely cast them but the cost may be more then they can be found.
Jim